Verified license

Frank Morgan

Willis, TX · Montgomery CountyPump installation

Call (210) 434-7867
Directions
License status
Active
checked September 29, 2026
License number
55028
Texas record
Services
2
Pump Installation and more

About Frank Morgan

Frank Morgan is a pump installation contractor based in Willis, TX (Montgomery County). The Texas licensing program lists license 55028 as active, and we last checked the record on September 29, 2026.

The state record covers pump installation and pump repair.

This profile is built from public state license records checked on September 29, 2026. Well Water Insider does not rate or endorse contractors. Own this business? Claim the profile to add photos, hours and a description.

License record

Verified against state records
License number
55028
License type
Pump installation
Status
Active
Expires
June 25, 2028
Last verified
September 29, 2026

Check this license yourself on the official Texas lookup.

What the state record says

Licensed by the Texas Department of Licensing and Regulation (TDLR) as a pump installer (pump endorsements: single-phase pumps, three-phase pumps, line-shaft turbine pumps). License 55028, expires 2028-06-25. No well reports filed with the Texas Water Development Board since 2016 under this license (pump-only work and repairs are not reported).

Services

What the Texas record says Frank Morgan is licensed or registered to do.

Pump Installation

Setting a new submersible or jet pump with the pressure tank, switch and controls.

Pump Repair

Tracking down low pressure, short cycling or no water, then repairing or replacing parts of the pump system.

Service area

Based in Montgomery County, Texas.

Approximate location (Montgomery County)

Well water in Montgomery County

Useful context before you call a contractor here.

8%of households in Montgomery County drink from a private well (est.)
Not statewidewater test when a home with a well is sold: no statewide rule in Texas
Open the Montgomery County well guide

Typical costs for these services

National ranges to help you read a quote. They are not prices from Frank Morgan; ask for a written estimate.

Submersible pump replacement$1,000 to $2,500installed; deep wells cost more
Pressure tank replacement$800 to $1,500installed

National 2026 ranges. Sources, checked September 2026: HomeGuide cost guides, Angi.

Before you hire

  1. 1

    Confirm the license

    Look up license 55028 on the Texas state lookup and make sure it is active for the work you need. Open the Texas lookup.

  2. 2

    Get a written estimate

    Ask for the scope, parts, depth or pump size, permit fees and warranty in writing. Compare two or three quotes for big jobs.

  3. 3

    Ask about permits and the well log

    New wells and many repairs are reported to the state. Ask who files the paperwork and for a copy of the well log.

  4. 4

    Test the water after the work

    Any work on a well can disturb bacteria. Test for coliform bacteria once the job is done.

Questions about Frank Morgan

Is Frank Morgan licensed?

Yes. The Texas record shows license 55028 (pump installation) with the status "active", last checked on September 29, 2026. You can confirm it on the state lookup.

What services does Frank Morgan offer?

The state record lists pump installation and pump repair. Call to confirm they take on your type of job.

What areas does Frank Morgan serve?

The business is based in Montgomery County (Willis, TX).

How do I contact Frank Morgan?

Call (210) 434-7867. The address on the state record is 18150 I 45 N, Willis, TX 77318.

Other licensed contractors near Willis