Verified license

Stewart Brothers Drilling

Milan, NM · Cibola CountyWell drilling and pump installation

Call (505) 287-2986
Directions
License status
Active
checked September 29, 2026
License number
50090
NM record
Services
6
Geothermal and more
Counties served
5
on the state record
Licensed in
2 states
NM and TX

About Stewart Brothers Drilling

Stewart Brothers Drilling is a well drilling and pump installation contractor based in Milan, NM (Cibola County). The NM licensing program lists license 50090 as active, and we last checked the record on September 29, 2026.

The state record covers geothermal, pump installation, pump repair, well abandonment, well drilling and well repair. It lists 5 counties where the business works, including El Paso County, Martin County and Midland County. The business also holds a license in Texas.

This profile is built from public state license records checked on September 29, 2026. Well Water Insider does not rate or endorse contractors. Own this business? Claim the profile to add photos, hours and a description.

License record

Verified against state records
License number
50090
License type
Well drilling and pump installation
Status
Active
Expires
April 12, 2028
Last verified
September 29, 2026

Check this license yourself on the official NM lookup.

Also licensed in

  • Texas: license 50090, well drilling and pump installation, expires April 12, 2028 (state lookup)
What the state record says

Licensed by the Texas Department of Licensing and Regulation (TDLR) as a water well driller and pump installer (drilling endorsements: water wells, monitoring wells, closed-loop geothermal wells; pump endorsements: single-phase pumps, three-phase pumps). License 50090 held by Randal P Stewart, expires 2028-04-12. Filed 19 well reports with the Texas Water Development Board since 2016, most recently in June 2026, mostly in El Paso, Martin and Midland counties.

Texas: Licensed by the Texas Department of Licensing and Regulation (TDLR) as a water well driller and pump installer (drilling endorsements: water wells, monitoring wells, closed-loop geothermal wells; pump endorsements: single-phase pumps, three-phase pumps). License 50090 held by Randal P Stewart, expires 2028-04-12. Filed 19 well reports with the Texas Water Development Board since 2016, most recently in June 2026, mostly in El Paso, Martin and Midland counties.

Services

What the NM record says Stewart Brothers Drilling is licensed or registered to do.

Geothermal

Drilling closed-loop boreholes for ground-source heat pumps.

Pump Installation

Setting a new submersible or jet pump with the pressure tank, switch and controls.

Pump Repair

Tracking down low pressure, short cycling or no water, then repairing or replacing parts of the pump system.

Well Abandonment

Sealing an unused well to state standards so it cannot carry surface water down into the aquifer.

Well Drilling

Drilling a new private well, setting the casing and grouting it the way state rules require.

Well Repair

Fixing casings, caps, pitless adapters and other parts of an existing well.

Service area

Based in Cibola County, NM. The state record lists 5 counties.

Business address

  • El Paso County
  • Martin County
  • Midland County
  • Reeves County
  • Ward County

Typical costs for these services

National ranges to help you read a quote. They are not prices from Stewart Brothers Drilling; ask for a written estimate.

Submersible pump replacement$1,200 to $4,500parts and labor
Pressure tank replacement$400 to $1,200installed
New well drilled$5,500 to $25,000about $25 to $65 per foot
Shock chlorination$80 to $300or about $20 as a DIY job

Before you hire

  1. 1

    Confirm the license

    Look up license 50090 on the NM state lookup and make sure it is active for the work you need. Open the NM lookup.

  2. 2

    Get a written estimate

    Ask for the scope, parts, depth or pump size, permit fees and warranty in writing. Compare two or three quotes for big jobs.

  3. 3

    Ask about permits and the well log

    New wells and many repairs are reported to the state. Ask who files the paperwork and for a copy of the well log.

  4. 4

    Test the water after the work

    Any work on a well can disturb bacteria. Test for coliform bacteria once the job is done.

Questions about Stewart Brothers Drilling

Is Stewart Brothers Drilling licensed?

Yes. The NM record shows license 50090 (well drilling and pump installation) with the status "active", last checked on September 29, 2026. You can confirm it on the state lookup.

What services does Stewart Brothers Drilling offer?

The state record lists geothermal, pump installation, pump repair, well abandonment, well drilling and well repair. Call to confirm they take on your type of job.

What areas does Stewart Brothers Drilling serve?

The business is based in Cibola County (Milan, NM). The state record lists 5 counties, including El Paso County, Martin County, Midland County, Reeves County and Ward County.

How do I contact Stewart Brothers Drilling?

Call (505) 287-2986. The address on the state record is 306 AIRPORT RD, Milan, NM 87021.

Other licensed contractors near Milan