Treatment planner

Well water treatment planner

Enter the numbers from your lab report. The planner checks each result against EPA limits, picks the treatment that fits the level, puts it in the right order and sizes your softener, with installed cost ranges.

  • You needYour lab report
  • Takes3 minutes
  • CostFree, no sign-up
How it works

What this tool is based on

Each result is compared with the EPA drinking water standard or guideline for it. Treatment is chosen by level, using the ranges Penn State Extension publishes: a softener handles dissolved iron under 5 mg/L when pH is above 6.7 and hardness is 3 to 20 grains; oxidizing filters cover combined iron and manganese of 3 to 10 mg/L; chlorination with filtration covers higher levels. Hydrogen sulfide follows the same approach by concentration.

Softener size follows Penn State Extension's method: people times daily water use times hardness gives grains per day. Daily use is EPA's figure of 82 gallons per person at home, and the softener is sized to regenerate about once a week, the usual target. Iron the softener removes is counted at the common rule of about 4 grains per mg/L.

UV only works on clear water, so the planner checks your results against the pre-treatment limits a county health department requires for UV (iron 0.3, manganese 0.05, hardness 300 mg/L, hydrogen sulfide 1 mg/L).

Installed costs are national 2026 ranges from HomeGuide, and Angi for shock chlorination. Confirm the plan with a water treatment professional, and retest after installation.

Questions

Good to know

What order should treatment equipment go in?

Sediment filter first, then pH correction, then iron, manganese and sulfur removal, then the softener, then carbon, with UV last so it sees the cleanest water. Drinking water units such as reverse osmosis go at the kitchen tap.

Will a softener remove iron?

Up to a point. Penn State Extension says a softener can remove dissolved (clear) iron below 5 mg/L when pH is above 6.7, but iron that has already turned red clogs the resin. Above that, or with manganese or a sulfur smell, use an oxidizing filter first.

How much sodium does a softener add?

Penn State Extension puts it at 7.5 mg per quart for every grain per gallon of hardness removed. If someone in the house is on a low-sodium diet, drink from a reverse osmosis tap or a bypassed cold line.