Private well guide

Well Water in Maryland: Testing, Rules, Labs and Licensed Contractors

About 731,000 people in Maryland get their water from a private well, by the U.S. Geological Survey's estimate. Here is what the state requires, where to get it tested, and who is licensed to work on it.

143Licensed contractorschecked against state records
20Certified labsfrom the state certified list
23Counties covered
731,000People on private wells13% of residents (USGS, 2010)

The short version: About 731,000 Marylanders, 13% of residents, drink from a private well (USGS estimate, 2010). The Maryland Department of the Environment gives the same 13%. Maryland checks the water of a new well: it isn’t signed off until it passes the county’s potability tests, usually bacteria plus a chemical panel, with arsenic or radium in some counties. After that first test, retesting is up to you.

Maryland at a glance
Permit to drill a home well Yes, a well construction permit from the county health department
Who can drill it A well driller licensed by the State Board of Well Drillers
Water test for a new well Required. The water must pass the county’s potability tests (bacteria plus a chemical panel) before the county issues a certificate of potability. Some counties add arsenic or radium
Water test when a home sells Not required statewide (a few counties require one, and some lenders do)
Most common problem Coliform bacteria, everywhere in the state
Typical household well depth Depth varies widely across the state. Logs of nearby wells are the best guide (ask the county health department, or try our well record lookup)
Where to test A lab certified by the Maryland Department of the Environment (MDE)

Who is in charge of a Maryland well

Two state bodies and 24 county health departments share the job:

Agency What it handles
Maryland Department of the Environment, Water Supply Program Writes the well construction rules in COMAR 26.04.04 and certifies the laboratories
State Board of Well Drillers Licenses master and journeyman drillers, pump installers and water conditioner installers as individuals, and publishes a monthly roster
County health departments Act as MDE’s approving authority: issue the well construction permit, inspect the grouting, keep the well completion report and issue the certificate of potability, without which the house cannot be occupied

There is no state well database. Your well record is at the county.

What is required, and what is left to you

Maryland checks both how a well is built and what comes out of it the first time. Every new well needs:

  • A permit. The county health department issues it before drilling.
  • A licensed driller. The driller must hold a State Board license.
  • Construction to the state standard. Grouted casing, 100 feet from a septic tank or drainfield (50 feet where the well draws from a confined aquifer), and minimum yields by use.
  • A passing potability test before occupancy. The well must pass the county’s potability tests, usually bacteria plus a chemical panel. Anne Arundel County, for example, requires two passing bacteria tests in a row, a chemical test, and radionuclide, arsenic and cadmium tests where they apply.

After that it is yours. Maryland does not require retesting, and only a handful of counties look at the well again when a property changes hands. Here’s where the state stands:

At a glance

Water test for a new wellRequired

Yes. A well construction permit from the county health department is required before drilling, the well must be built by a Maryland licensed well driller to COMAR 26.04.04 (grouted casing, 100 ft from a septic tank or drainfield, or 50 ft where the well draws from a confined aquifer, minimum yields by use), and before the house can be occupied the county issues a certificate of potability based on a sample from an MDE-certified lab that passes the county's potability tests, usually bacteria plus a chemical panel. Several counties add tests (Anne Arundel, for example, requires two consecutive passing bacteria tests, one chemical test, and radionuclide, arsenic and cadmium tests where applicable). The driller files the well completion report with the county.

Water test when a home is soldNot required statewide

No statewide requirement. Maryland's residential disclosure asks about the water supply and known problems, and a few counties require a bacteria test or a yield test when a property on a well changes hands (check the county health department). Some lenders require a water test before closing.

What the state recommends

University of Maryland Extension and MDE recommend testing a private well every year for coliform bacteria and nitrate, and every three years for pH, hardness, iron, manganese, lead, copper and total dissolved solids. Add arsenic and radium in the Coastal Plain (the Aquia and Patuxent aquifers under Anne Arundel, Calvert, Prince George's and the Eastern Shore), radon and uranium in the Piedmont, PFAS near Patuxent River, Fort Meade and other airfields, chloride and sodium on the lower Eastern Shore, and test again after flooding, well work or a change in taste, color or smell.

Free or low-cost testingAvailable

No free program. The county health departments do not run labs but will tell you which certified labs serve the county, and several commercial labs on the MDE list (Water Testing Labs of MD, Home Land Labs, Fredericktowne Labs, Certified Water Testing, Chesapeake Environmental) are built around homeowner samples and run the potability panel. University of Maryland Extension's Wells and Septic Systems program runs periodic free screening clinics.

What the water is like in each part of Maryland

The fall line through Baltimore and Washington divides Maryland’s groundwater. Find your side below.

Region Typical household well What to expect
Piedmont, west of the fall line (Montgomery, Howard, Baltimore, Carroll and eastern Frederick counties) Into fractured granite, gneiss and schist. Depth varies, so check logs of nearby wells Modest yields, and a dry hole is possible. The water is soft and acidic enough to corrode copper plumbing, and the rock gives off radon and, in places, uranium.
Eastern Shore Coastal Plain In stacked sand aquifers. Depth varies, so check logs of nearby wells Plentiful water. The shallow Columbia aquifer under the poultry counties carries nitrate, the Aquia under the upper Shore carries naturally occurring arsenic, the sands bring iron and manganese, and the lower Shore and Bay-front wells can pick up salt.
Southern Maryland and Anne Arundel Varies by aquifer, so check logs of nearby wells The Aquia aquifer under Anne Arundel and Calvert carries arsenic, and the Patuxent and Patapsco under Southern Maryland carry radium, which is why these counties test for them at potability.
Hagerstown Valley and the western mountains (Washington, Allegany and Garrett counties) Varies. Check logs of nearby wells Hard limestone water in the Hagerstown Valley, through karst that lets bacteria in after rain. In Garrett and Allegany, wells go into sandstone and shale with iron and sulfur.

One thing is the same everywhere: bacteria is the test Maryland wells fail most often.

What to test for

This follows the testing guidance from University of Maryland Extension.

Test How often Who needs it
Total coliform bacteria, E. coli and nitrate Every year Every well, and especially homes with a pregnant woman, an infant or young children
Chloride, copper, hardness, lead, manganese, pH, sulfate and total dissolved solids The first time you test, then every 3 years Every well
Arsenic and radium The first time you test, then as your county health department advises Coastal Plain wells in the Aquia and Patuxent aquifers (Anne Arundel, Calvert, Prince George’s and the Eastern Shore)
Radon and uranium The first time you test, then as your county health department advises Piedmont wells
Chloride and sodium Add to the every-3-years check Lower Eastern Shore wells
PFAS Once Wells near Patuxent River, Fort Meade and other airfields
Retest After well repairs or new parts, a fuel or chemical spill nearby, a neighbor’s bad result, unexplained stomach illness, or a change in taste, odor, color or clarity Every well

Why bacteria gets top billing: in a University of Maryland study of 118 private wells in four Maryland counties, total coliform bacteria turned up in 25.4% of them and E. coli in 3.4%. About 26% missed the pH standard, which matters because acidic water pulls lead and copper from plumbing, and 43.2% failed at least one federal health-based standard. Your potability test was one snapshot, years ago. If a result comes back bad, our shock chlorination calculator, arsenic guide, uranium guide and treatment sizing tool walk you through the next step.

MDE-certified labs

Maryland’s county health departments don’t run labs, so every test goes to a certified commercial lab:

Option Best for Cost
Homeowner-focused certified lab with local drop-off The yearly bacteria and nitrate check, the potability panel, or a lender’s test Varies by lab
Lab certified for a specific group Arsenic, radium, radon, VOCs or PFAS Varies by lab

Maryland has no free testing program, but your county health department will tell you which certified labs serve the county, and University of Maryland Extension’s Wells and Septic Systems program runs periodic free screening clinics.

MDE certifies drinking water laboratories for public water systems and for the potability test, so unusually the certified list is full of labs that live on homeowner samples: Water Testing Labs of MD, Home Land Labs, Fredericktowne Labs, Certified Water Testing, Fountain Valley and Chesapeake Environmental among them, most with drop-off points across their region and mail-in bottles. Utility and treatment plant labs have been left off. Every lab below comes from the MDE certified list revised August 2026, with the tests each is certified to run.

See all 20 certified labs in Maryland

Licensed well drillers, pump installers and water conditioner installers

Three things to know before you hire in Maryland:

  • Maryland licenses the individual, not the company. Ask who on the crew holds the license and check the number.
  • There are three trades. Well drillers, pump installers and water conditioner installers are each licensed, as masters or journeymen.
  • Licenses run through June 1, 2027. The State Board publishes a monthly roster of active licensees.

Every profile below is built from the State Board of Well Drillers roster of active licensees dated September 2026, grouped under the business each licensee works for, with the master and journeyman well drillers, pump installers and water conditioner installers named and their license numbers shown. Apprentices and rig operators are counted but not named. Companies that hold only geotechnical or apprentice licenses are left off.

See all 143 licensed contractors in Maryland

By county

Well use swings hard from county to county. These shares come from the same USGS 2010 estimate:

  • Fewest: almost nobody in Baltimore City, 1% of residents in Prince George’s County and 4% in Montgomery
  • About a quarter: Frederick (26%), Charles (24%) and Harford (23%) counties
  • Half or more: Caroline (66%), Garrett (55%), Somerset (52%) and Queen Anne’s (52%) counties

Each county page carries its well population, the nearest certified labs and the licensed contractors based there.

Maryland well water questions

Do I need a permit to drill a well in Maryland?

Yes. The county health department issues the well construction permit, the driller must hold a State Board license, and the county inspects the well and issues a certificate of potability after the water passes the county’s potability tests (bacteria plus a chemical panel, and arsenic, radium or other tests in some counties).

Is a water test required when I sell my house?

Not by the state. A few counties require a bacteria or yield test at transfer, and some lenders require a water test before closing.

How often should I test my well in Maryland?

University of Maryland Extension says every year for total coliform bacteria, E. coli and nitrate, and every 3 years for a broader chemistry check, plus the tests that fit your geology: arsenic and radium in the Coastal Plain, radon in the Piedmont. Test again after well repairs or any change in the water.

How do I find the record for my well?

Call the environmental health office of the county health department where the well is. It holds the well completion report and permit file. Maryland has no statewide online well database.

Which lab should I use?

Any lab on the MDE certified list above. For the yearly bacteria and nitrate check, the homeowner-focused labs with local drop-off points are the easiest. For arsenic, radium, radon, VOCs or PFAS, pick a lab certified for that group.

My county tested for arsenic when the well was drilled. Do I need to keep testing?

Yes, every few years. Arsenic and radium levels in Coastal Plain wells change slowly but they do change, and a treatment unit installed to pass the potability test needs its own yearly check to prove it is still working.