Waypoint Analytical
GA certified
- Coliform Bacteria
Georgia county well guide
Well Water in Haralson County, GA: Testing, Contractors and Rules
About 2,021 households in Haralson County, 18% of the county, rely on a private well. Nobody tests that water unless the owner does.
of households on a private well
Share on wells, county vs state
0licensed contractors serve the county
<1 mito the nearest certified lab, Waypoint Analytical
Nostatewide test required when a home is sold
Haralson County has an estimated 2,021 households on private wells, 18% of the county. If you are one of them, testing, treatment and repairs are yours to arrange.
Local rules for wells in Haralson County
Private wells in Haralson County follow Georgia's statewide rules, administered by Georgia Environmental Protection Division and the State Water Well Standards Advisory Council. No water test is required by the state when a new well is completed. There is no statewide test requirement when a home is sold, though lenders often ask for one. The cards below show the details and the official sources.
At a glance
Water test for a new wellNot required statewide
No statewide water test and no state permit for an individual household well. The Water Well Standards Act requires the well to be drilled by a licensed water well contractor to the state construction standards (grouted casing, 10 ft from property lines, 50 ft from septic tanks and 100 ft from drainfields), and the contractor must disinfect it and give you a well record. Several counties, mostly in north Georgia and around Atlanta, require a well permit and a bacteriological test through the county environmental health office before the well is used, so check with your county.
Water test when a home is soldNot required statewide
No statewide requirement. The seller's disclosure only says whether the property is on a well. FHA, VA and USDA loans normally require a bacteria, nitrate and lead sample from a certified lab before closing, and a few county health departments require a well inspection at transfer.
What the state recommends
The Department of Public Health and UGA Extension recommend testing a private well for coliform bacteria every year and running the UGA basic water test (pH, hardness, nitrate and about 20 metals including iron, manganese, lead, copper and arsenic) every two to three years. Add radon and uranium in the Piedmont and the mountains, sodium and chloride near the coast, and test again after flooding, well work or a change in taste, color or smell.
Free or low-cost testingAvailable
Every county has a UGA Cooperative Extension office that sells the UGA water test kits at cost: the basic chemistry test (W1) and the bacteria test (W33) run roughly $30 to $50 each, with results explained by the county agent. Extension and the county health departments also run periodic free or discounted testing days, and several county environmental health offices test bacteria for a small fee.
Getting your water tested near Haralson County
1 certified lab within 40 miles serves Haralson County, starting with Waypoint Analytical in Bremen (in the county). Each card below shows whether the lab takes homeowner samples and which tests it is certified for.
1 certified labs within 40 miles
Licensed well contractors serving Haralson County
No licensed contractor lists Haralson County as a home base or service area yet. The finder below searches the whole state; most drillers travel several counties for a job.
No listings yet for this area. Try widening your search.
Well depth and water chemistry
Wells in Haralson County typically reach 200 to 500 ft in the fractured granite and gneiss of the Piedmont and north Georgia mountains, where yields are modest; 100 to 400 ft in the Floridan and Claiborne aquifers of the Coastal Plain south of the fall line, deeper (400 to 800 ft) in the southwest; shallow surficial wells of 30 to 100 ft along the coast and in the flatwoods feet. What comes up with the water depends on the aquifer, and across Georgia the usual suspects are coliform bacteria (statewide, worst in shallow and older wells), acidic corrosive water that pulls lead and copper from plumbing (piedmont and mountains), iron and manganese (piedmont and coastal plain). A first full panel tells you which of them apply to your well.
Typical well depth
Varies by location. Check the state well record search for logs of nearby wells.
Contaminants to test for
- Coliform bacteria (statewide
- Worst in shallow and older wells)
- Acidic corrosive water that pulls lead and copper from plumbing (Piedmont and mountains)
- Iron and manganese (Piedmont and Coastal Plain)
- Radon and uranium (Piedmont granite
- North metro Atlanta counties)
- Hardness and hydrogen sulfide (Floridan aquifer in south Georgia)
- Nitrate (southwest Georgia farm country
- Shallow Coastal Plain wells)
- Arsenic (locally in the Piedmont and Coastal Plain)
- Saltwater intrusion (Brunswick and the coastal islands)
- PFAS near carpet mills in northwest Georgia and near airfields
Neighboring counties: Carroll County, Polk County, Paulding County, Douglas County.
What well work costs in Haralson County
Basic bacteria and nitrate test$25 to $75lab fee, homeowner sample
Full panel lab test$150 to $400metals, VOCs, radiologicals
Well inspection$250 to $550flow, pressure, visual, water test
Submersible pump replacement$1,200 to $4,500parts and labor
Pressure tank replacement$400 to $1,200installed
Whole-house treatment system$800 to $6,000softener, iron filter, UV, RO
New well drilled$5,500 to $25,000about $25 to $65 per foot
Shock chlorination$80 to $300or about $20 as a DIY job
National ranges from published 2025 to 2026 contractor pricing. Local quotes vary with depth, access and materials.
Questions Haralson County well owners ask
How many homes in Haralson County are on a well?
About 2,021, or 18% of households, based on Census housing data and state well surveys. The share is highest outside the towns with public water.
Where is the closest certified lab to Haralson County?
Waypoint Analytical in Bremen, inside the county. Call first to ask whether they accept homeowner samples.
Do I need a permit to drill a well in Haralson County?
No statewide water test and no state permit for an individual household well. The Water Well Standards Act requires the well to be drilled by a licensed water well contractor to the state construction standards (grouted casing, 10 ft from property lines, 50 ft from septic tanks and 100 ft from drainfields), and the contractor must disinfect it and give you a well record. Several counties, mostly in north Georgia and around Atlanta, require a well permit and a bacteriological test through the county environmental health office before the well is used, so check with your county.
What does a well test cost near Haralson County?
A bacteria and nitrate test runs $25 to $75 at most certified labs; a full panel with metals is $150 to $400. Mail-in kits cost about the same as walking in.